Altana Esp-10 Uživatelský manuál Strana 23

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 30
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 22
After the impact use adhesive
tape to remove loose paint
particles from the test surface.
Measure the width B of the area
chipped off and round up to a
whole number (mm). The width of
the wedge-shaped tool that
penetrated into the basis material
is not to be considered.
6. Measuring the Impact
Determine the separation plane.
If there are several separation
planes estimate the percentage of
the damaged area. In case of
doubt and especially in case of
slight color differences it is
recommended to use a
microscope for a precise
determination of the separation
planes.
approx. 100 μm
Impact Tool
Fig. 2 Multi-coat System with Impact Tool
- Finishing Paint
- Filler
- Priming Coat
- Phosphating
- Panel
Zobrazit stránku 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

Komentáře k této Příručce

Žádné komentáře